Control - Monitoring - Documentation

HS 100 can be combined with all almost all controlled rectifiers. The analog and digital interface of the HS 100 can be adapted in most cases to the rectifier needs.

This dedicated process controller provides you with the flexibility needed to cope with the different requirements given to successfully anodise various aluminium alloys. In addition to the standard DC mode you can also apply various pulse patterns to the load being anodized.
 
Ramping, pulse operation, current control, voltage control - all these features are considered in the HS100.

By means of the programme buttons P 1 – P 36 you can activate one of the 36 available programmes. Each programme can consist of up to 10 steps. For each step you can use one of the following functions to create a complete programme sequence (ramp, pulse, hold, repeat). In such a way you can define various different ramping cycles or pulse cycles within one programme. The desired current or voltage value can be individually defined for each step of the process.

Additionally, the HS 100 is also featured with an Ah (min) -meter and a temperature sensor for measuring and displaying of the bath temperature.
(not applicable for every type of rectifier!)  

The advanced pulse function allows you to set your individual pulse pattern. The pulse function is supported in current, voltage and surface control mode. The pulse time can vary from a few seconds to a couple of minutes.

The surface control mode is another advanced control feature to simplify operation.

HS 100 - the first of its kind.